If you’re looking to Sell Fluke Networks TN2100 Enhanced Terminator
Fluke Networks TN2100 Enhanced Terminator
“Terminate” wasted time, money and dispatches
Just attach the battery-powered Terminator to the far end of a cable pair. Together with a single 990 CopperPro, Terminator provides VF and WB terminations and tones for terminated transmission testing. It also supports the 990DSL’s composite tone generation capability for high-speed ADSL, special services, and wideband longitudinal balance tests. The bottom line? By reducing failure frequency, repeats and chronic problems, Terminator puts an end to unnecessary dispatches and fines.
Save time and money. Gain higher performance.
- Saves money and optimizes your workforce with “one tech out” terminated testing of out-of-service pairs
- High-speed acceptance/qualification tests, including loop attenuation – a must for HDSL2/4
- Robust error checking at start-up eliminates time-consuming false starts and assures reliable communication with the CopperPro
- High-speed testing makes technicians more efficient; the CopperPro’s unique composite tone capability can sweep thousands of frequencies in seconds
Terminator: one add-on module; 13 testing advantages
- Loop terminations and VF/WB single tones for testing on either of two pairs (Pair 1 and 2)
- Bridging/splitting access between Pair 1 and Pair 3 (CO Pair)
- Composite VF and WB tones for greatly increased testing speed
- DTMF signaling control on both Pair 1 and Pair 2 (Pair 1 alone, if powered down)
- Signaling and testing on the same pair (either Pair 1 or 2)
- Extremely low-power mode when turned off
- DTMF transceiver switchable via relay to either Pair 1 (default) or Pair 2, or removed from both for a preset time interval whenever its input impedance would affect the 990 CopperPro measurement from the far end (i.e., shorts and grounds, or opens)
- Operable from a standard butt-set, when line powering is present (i.e., idle POTS line)
- DTMF command protocol allows for “Ack/Nack” closed-loop feedback response to control commands, increasing reliability
- Tracing Tone mode (TR metallic 577 Hz signal)
- Powered by a standard, off-the-shelf 9 VDC alkaline non-rechargeable battery
- Battery cover removable without using a tool
- Operates from an external 12-15 VDC power source, such as the AC and DC power cords provided with the 990 CopperPro, automatically disconnecting the internal battery when plugged in
Buying, Selling, Trading Fluke Networks TN2100
SIf you’re selling your Fluke Networks TN2100 please fill out form on the right hand side of page.